Domestic Gates Maintenance Support Domestic Gates In Operation Enquiries Contact
Established in 1986
Climate Auto Gates

Job Vacancies

commercial gates
commercial gates
spacer
Support

Faults   Actions Following Power Cuts   Changing Timers
Changing Videx Keypad Codes

Faults

Gate won't close / stuck open / won't open

Gate won't close / stuck open / won't open

Another common reason for the gates staying open is that the induction loop detector has locked out. To reset the system make sure there are no vehicles or metal objects parked on or near the loop or in the gateway, then switch the isolator off for 30 seconds then back on again, give the gate an open command, wait five minutes and the gates should close.

Finally check the safety beam system shown below. If the lenses are dirty or some vegetation has grown in front of them no matter how small, this will cause the safety system to detect and hold the gates open. Remove any vegetation, clean lenses, stand clear and allow a few minutes for the gates to close.

In Severe Winter Conditions Snow and Ice can Build up on the Safety Beams causing Gates

to Stay open, also snow and ice can build up on the front of gates, which causes constant open

and close cycle. In this situation simply cleaning the Snow and Ice away will solve the problem.

Safety Beams

 

 
Top
 
back to top